DJI
Quick-Release Clamp (T100/T70P/T25P) YC.JG.ZS004696
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
This clamp is part of the quick-release latches that hold the auger motor end on DJI Agras T100, T70P and T25P spreaders. Every parts diagram that shows it numbers it just ahead of the quick-release rod.
| Part number | YC.JG.ZS004696 |
| Fits | DJI Agras T100, T70P, T25P |
| Parts diagram | T100 spreading auger, callout 30; T70P spreading auger, callout 30; T25P spreader (sheet 1), callout 38 |
DJI's product information shows a latch either side of the auger motor end. Both are opened to draw out the motor end and auger, then closed once the alignment marks line up, and the T100 and T70P parts photo shows two matching clamps. A worn or broken clamp shows up as a latch that no longer closes cleanly or holds firmly. Look for cracks around the pin holes and wear on the bearing faces, and replace the clamp before trusting the latch again.
Clean grit out of the latch before fitting the new clamp so it seats properly, then refit the circlips and try the latch several times by hand. While it is apart, look over the medium pin numbered just before it on the T100 and T70P sheets.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
