DJI
20-pin Connector Sealing Ring (T100) YC.JG.MY001989
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Sealing ring for the 20-pin connector in the DJI Agras T100 spray tank assembly. Together with the connector's plastic cover, it helps keep washdown water and spray residue off the pins, where corrosion can cause electrical faults.
| Part number | YC.JG.MY001989 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 spray tank (sheet 2), callout 15 |
DJI's photo sheet lays it beside the 20-pin plastic cover (callout 13), with the M25 screws (callout 14) close by. A healthy ring is supple, unbroken and springs back when pressed. One that stays flattened, shows nicks or splits, or has swollen from chemical contact can no longer be trusted to seal. Fit a new ring whenever the cover is opened, and check it sits evenly in its seat before the screws go back in.
Its code, YC.JG.MY001989, differs from the 16-pin ring (YC.JG.MY001811). If the 20-pin connector plastic cover is cracked, replace it at the same time, along with any worn M25 screws.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
