DJI
20-pin Connector Plastic Cover (T100) YC.JG.ZS006858
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Of the two connector covers in the DJI Agras T100 spray tank assembly, this is the 20-pin one, pictured by DJI just below the payload control board. It helps protect the 20-pin connector from knocks, dirt and water.
| Part number | YC.JG.ZS006858 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 spray tank (sheet 2), callout 13 |
Its sealing ring (callout 15) and M25 screws (callout 14) are laid out beside it on the sheet. Look it over whenever the tank wiring is apart: a crack, a chipped edge or warping is reason enough to replace it, because a cover that no longer sits flat leaves a path for water around the pins. The 16-pin connector on the same tank uses a different cover (YC.JG.ZS006291), so order by code rather than by appearance.
Renew the 20-pin connector sealing ring whenever the cover is removed, and replace any M25 screw with a worn drive.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
