DJI
Weight Sensor Rubber Cover (T100/T70P) YC.JG.MY001377
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Both the DJI Agras T100 and T70P use this round rubber cover in their spreading weight sensor hardware, and it carries the same part code on each aircraft's diagram.
| Part number | YC.JG.MY001377 |
| Fits | DJI Agras T100, T70P |
| Parts diagram | T100 spreading weight sensor, callout 13; T70P spreading tank, callout 8 |
On the T100 sheet it is drawn directly below the rear weight sensor module (callout 12). On the T70P spreading tank sheet it follows the weight sensor module and damping rubber pad at callouts 6 and 7.
Rubber exposed to sun, heat and fertiliser eventually perishes. Check the cover at each clean-down and replace it if it is torn, hard or no longer sits snugly. Rinse around it rather than aiming a pressure washer straight at it.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
