DJI
Weight Sensor Signal Cable (T100) YC.XC.XX001402
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Weight readings from the DJI Agras T100 spreading system travel through this signal cable, callout 1 on the weight sensor diagram. It is a T100 part only: the T70P uses a different weight sensor cable, YC.XC.XX001401.
| Part number | YC.XC.XX001402 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 spreading weight sensor, callout 1 |
A cable fault can look just like a sensor fault, with a payload figure that drops out, freezes or jumps. Before buying a sensor module, trace this cable for chafing anywhere it rubs against the frame, crushed or kinked sections, and corroded or bent plug pins. The harness splits into several branches, each ending in a plug, so check every one of them.
Route the new cable along the original path and refit its clamps and ties so nothing can chafe or pinch it. If the cable proves sound, move on to the front weight sensor module and its rear counterpart.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
