DJI
Damping Rubber Pad (T100) YC.JG.MY001915.03
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Square and made of rubber, this damping pad sits in the weight sensor assembly of the DJI Agras T100 spreading system, cushioning the sensor mounting against shock and vibration. It is callout 3, drawn beside the spread tank connector.
| Part number | YC.JG.MY001915.03 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 spreading weight sensor, callout 3 |
Rubber in this spot lives with vibration, fertiliser dust and wash-down water, and over time it hardens, tears or squashes flat. A pad in that state has stopped doing its job, so renew it rather than packing it out, and don't cut a substitute from sheet rubber: its hole pattern has to match the parts it sits against.
Seat the new pad flat with every hole lined up before anything is tightened down. While the weight sensor hardware is apart, look over the front weight sensor module and the weight sensor pin shaft as well.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
