DJI
Flow Meter Adapter (T100/T70P) YC.JG.ZS006199
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
On the DJI Agras T100 and T70P, the flowmeter adapter is the fitting that joins the spray plumbing to the flowmeter module. Its joint is sealed by a dedicated adapter sealing ring, sold as a separate part.
| Part number | YC.JG.ZS006199 |
| Fits | DJI Agras T100, T70P |
| Parts diagram | T100 flowmeter, callout 2; T70P flowmeter, callouts 11 and 17 |
Both diagram photos lay out four adapters, a pair above the flowmeter module and a pair below it. The T70P sheet labels both pairs with this code, while the T100 sheet numbers only the upper pair. Replace an adapter if its body is cracked or distorted, or if the joint still weeps after a fresh seal has gone in.
Any time the adapter comes off, fit a new flowmeter adapter sealing ring and look over the mating face of the flowmeter module, then test with clean water before going back to chemical.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
