DJI
Landing Gear Crossbeam - Rear, Spreading (T100) YC.JG.ZS007106
Shipping: Oversize Parcel, $67.50 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Fitted across the back of the DJI Agras T100 landing gear, this rear crossbeam belongs to the spreader-system configuration and is callout 12 on the second spreading landing gear sheet.
| Part number | YC.JG.ZS007106 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 spreading landing gear (sheet 2), callout 12 |
As a crossbeam it spans the gear from one side to the other. DJI sells the front crossbeam as a separate part on the same sheet, so check you are ordering the rear one. Inspect it for bowing, cracks at the mounting points and any fixings that have worked loose, especially after a hard or skidding landing.
The spotlight, its bracket and signal cable, and the payload adapter cable are shown on this sheet too. When refitting the crossbeam, make sure none of those leads is trapped or rubbing, then tighten the fixings evenly.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
