DJI
Hose Curving Connector - M15 (T50) YC.JG.ZS003478
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
An M15 hose curving connector from the flowmeter module of the DJI Agras T50. It is numbered 8 on the T50 flowmeter module sheet, beside the thumb nut and the flowmeter hoses.
| Part number | YC.JG.ZS003478 |
| Fits | DJI Agras T50 |
| Parts diagram | T50 flow meter module, callout 8 |
A curved connector that is cracked, has a damaged thread, or weeps at the joint will drip mix around the flowmeter and under the aircraft. Check the hose nut and sealing faces at the same time, start the thread by hand, and run clean water through the system to test the joint before spraying.
On the sheet it is listed with the flow meter water outlet hose (callout 5), the flow meter water inlet hose (callout 3) and the thumb nut (callout 6). This connector is listed for the T50 only.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
