DJI
Airframe Cable Clamp (T100) YC.JG.ZS006713
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Cables along the DJI Agras T100's middle frame are held in place by this airframe cable clamp, one of the clips that keep the wiring on its set route through the centre section.
| Part number | YC.JG.ZS006713 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 middle and rear frame (sheet 1), callout 10 |
| Supplied as | One clamp |
In the diagram it is drawn just above the in-position detector cable (callout 11). A clamp that has cracked, lost its grip or gone missing lets the cables move against the frame, and vibration will then wear through the insulation. Route the cables exactly as they were and make sure none are trapped under the clamp edge before securing it.
The diagram photo shows four of these clamps, so order one for each clamp you are replacing. The airframe cable cover and SDR cable clamp B0 from the same sheet are listed too.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
