DJI
SDR Cable Clamp B0 (T100) YC.JG.ZS006716
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
SDR cable clamp B0 holds the SDR (software-defined radio) cabling in place on the DJI Agras T100 airframe. It is callout 7 on the middle and rear frame sheet and is a separate part from clamp B1 at callout 13.
| Part number | YC.JG.ZS006716 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 middle and rear frame (sheet 1), callout 7 |
That cabling belongs to the aircraft's radio link, so it should stay where DJI routed it. A clamp with a snapped clip or a split body lets the cable shift under vibration, where it can chafe against the frame or pull on its connector. Check the clamp whenever the frame covers are off.
Seat the cable fully before closing the new clamp so it is held without being pinched. The airframe cable cover listed beside it is worth a look at the same time.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
