DJI
Hose Nut - M15 (T50/T25P) YC.JG.ZS003460
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Hose joints in the spray lines of the DJI Agras T50 and T25P rely on this M15 hose nut to stay tight. It is drawn on the M3 arm sheet for both aircraft and twice on the T50 spray lance.
| Part number | YC.JG.ZS003460 |
| Fits | DJI Agras T50, T25P |
| Parts diagram | T50 M3 arm, callout 14; T50 spray lance, callouts 12 and 13; T25P M3 arm, callout 34 |
A joint that weeps, drips from the arm after spraying, or a hose that works loose from its fitting can point to a cracked or cross-threaded nut, and dried chemical in the thread also stops it seating properly. Start the nut by hand, tighten it firmly without forcing it, and run clean water through the lines to check the joint before filling with mix.
On the T50 arm diagram it is listed beside the 180-degree elbow connector. The T50 spray lance uses a pair of these nuts, so check the second one while you are there. The T70P diagrams call for a different hose nut, YC.JG.ZS006165, so this one is not a T70P part.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
