DJI
Sealing Foam - 133.3 x 35.7 mm (T25P) YC.JG.MQ002641
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
A strip of sealing foam measuring 133.3 x 35.7 mm, used in the front frame of the DJI Agras T25P. It is callout 37 on the second front frame sheet, listed just before the front shell bottom plate.
| Part number | YC.JG.MQ002641 |
| Fits | DJI Agras T25P |
| Parts diagram | T25P front frame (sheet 2), callout 37 |
Foam strips like this close the gaps between panels against dust, water and spray drift. Replace it when it has torn, crumbled or set hard, or no longer springs back after the shell has been opened a few times. Remove every scrap of the old strip, clean the surface and let it dry fully, then lay the new piece down without stretching it.
The same sheet lists a smaller 59.5 x 19.3 mm sealing foam at callout 39, so check the size before ordering. The front shell bottom plate is listed between the two at callout 38.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
