DJI
Propeller Clamp (T100) YC.JG.QX004794
Shipping: Small Parcel, $15 Australia-wide
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Holding the blades on the motor is the job of this propeller clamp on the DJI Agras T100. The T100 propeller sheet shows it stacked with the M80 nut, the propeller gasket and the CW or CCW blades.
| Part number | YC.JG.QX004794 |
| Fits | DJI Agras T100 |
| Parts diagram | T100 propeller, callout 2 |
Check the clamp after any prop strike, tip-over or hard landing. Replace it if it is cracked or bent, or if its faces are scored or deformed; vibration that only appears after a knock can point to a distorted clamp. Wipe dried spray off the mating faces before reassembly so the stack seats flat.
Renew the M80 nut as well if its thread is marked, and look over the CW propellers and CCW propellers at the root while they are off.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
