DJI
Control Panel Rear Cover Rubber Sleeve (D14000iE) YC.DZ.GR000555
Shipping: Australia Post, priced for your postcode in the cart
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Protective rubber sleeve for the rear cover of the DJI D14000iE generator's control panel, shielding the wiring at the back of the panel from rubbing, dust and water.
| Part number | YC.DZ.GR000555 |
| Fits | DJI D14000iE Multifunctional Inverter Generator, Zongshen (ZS) engine |
| Parts list | D14000iE generator and frame, ref 94 |
Replace it if the rubber has split, hardened or gone missing. Without it, wiring at the back of the panel can chafe as the engine vibrates, and dust and water have an easier way in. Disconnect the starter battery before working behind the control panel, and check the controller to USB communication board cable for chafing while the cover is off. DJI first catalogued this sleeve for the D12500iE. DJI marks it for the Zongshen (ZS) engine build; D14000iE units built with a Rato engine take different parts here, so check the engine label before ordering.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
