DJI
Fuel Hose Clip (13 mm ID) (D14000iE) YC.DZ.GR000547
Shipping: Australia Post, priced for your postcode in the cart
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Plastic routing clip that holds the fuel hose in position on the DJI D14000iE generator. Its ring has a 13 mm internal diameter and the base pushes into a mounting hole.
| Part number | YC.DZ.GR000547 |
| Fits | DJI D14000iE Multifunctional Inverter Generator, Zongshen (ZS) engine |
| Parts list | D14000iE generator and frame, ref 43 |
The clip keeps the fuel line clear of hot parts and stops it rubbing against the frame as the generator vibrates. It is a locating clip, not a hose clamp, and does not seal the hose onto a fitting. Replace it if the ring has cracked, the base no longer stays put, or the hose hangs loose near the fuel pump. Check the hose for chafe marks at the same time, and make sure the pump protection cover is secure.
DJI marks this as a Zongshen (ZS) part; units built with a Rato engine take different engine parts, so check the engine label.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
