DJI
EFI Control Cable with Oxygen Sensor Cable (D14000iE) YC.DZ.GR000725
Shipping: Australia Post, priced for your postcode in the cart
Call AGX Drone Distributors: 1300 916 075
About
Specifications and fitment
Electronic fuel injection control wiring for the Zongshen engine on the DJI D14000iE generator, including the oxygen sensor lead, linking the EFI parts to the controls.
| Part number | YC.DZ.GR000725 |
| Fits | DJI D14000iE Multifunctional Inverter Generator, Zongshen (ZS) engine |
| Parts list | D14000iE engine, ref 75 |
Chafed insulation, melted sections near the exhaust, broken clips or corroded plugs can cause misfires, surging, hard starting or fault codes. Trace the loom and check each plug and the ground cable before replacing it, and disconnect the starter battery first. DJI also lists an ANZ edition under the same ref, code YC.DZ.GR001099, which DJI marks as an upgraded-version part. Check the code on your old harness, or contact us with the generator's serial number and a photo. D14000iE units built with a Rato engine take different engine parts, so check the engine label before ordering.
Why AGX?
We know you have a lot of options, but here's why you should shop with us.
Freight included
Kit orders are delivered to your farm anywhere in Australia at no extra cost.
Training available
Add onsite setup and training and fly the aircraft with one of our pilots before it goes to work.
Licensing help
We stay with you through the RePL, type rating, ReOC, and chemical licence rather than waving you off at the gate.
Parts on the shelf
Genuine spares stocked in Australia, so a repair is measured in days rather than weeks.
